Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Will Nano pi fire3 boards work for diy skymining?

Thank you I appreciate it.
(07-03-2018, 08:33 PM)Wompwillie Wrote:

Thank you I appreciate it.

I have not seen anyone using this specific board. I doubt there would be much issue but idk how well it would work. As long as it can install and compile go it should work fine. But using hardware like this leaves you open to possible issues that there is no documentation on.

If your good a linux it could be a fun project and worth getting done. But if your not very skilled with Linux then I suggest staying away from any and all hardware that are currnetly uncommon within the Skywire network. As you are never sure what hardships you are opening yourself up to.
I just ordered a K2 as a manager and 7 512mn NEOs. The NEOs come in a lit for $20 and come with memory cards and heat sinks.etc. I’ll let you know how they go when they arrive, not high spec, But should be fine using Ubuntu as a base

Forum Jump:

Users browsing this thread: 1 Guest(s)